Agri-fab 45-0345 User Manual download pdf (Page 8)

OPERATION

PUSH CART

IMPORTANT:

Leave the latch lock clevis pin in place at all

times while using the cart as a push cart. The clevis pin

is shown in ﬁ gure 1 on page 5.

1. To convert the cart for push operation, remove the 4" long

clevis pin and hair cotter pin which secure the tongue

in the towing position. (See ﬁ gure 10 on page 7.) Pivot

the front tongue into the storage position underneath

the rear tongue and secure it using the 4" long clevis pin

and hair cotter pin. (Refer to ﬁ gure 5 on page 6.) Place

the plastic cap over the exposed end of the tongue.

2. For best handling and to help prevent accidental tipping,

distribute the weight of the load evenly in the cart.

3. Do not load more weight into the push cart than you

can handle and control comfortably.

4. To dump material from the push cart, lift up on the

handle and tilt the cart forward.

Be sure

that the latch

mechanism on the tongue is locked and secured with the

clevis pin to prevent accidental release of the latch.

CAUTION: TO AVOID POSSIBLE

INJURY, BEFORE RELEASING THE

LATCH BE SURE THAT NO ONE IS

NEAR THE CART.

TOW CART

1. To convert the cart for towing, remove the plastic cap

from the tongue. Remove the 4" long clevis pin and

hairpin cotter which secure the front tongue in storage

position underneath the rear tongue. Pivot the front

tongue outward and secure it in the towing position

using the same clevis pin and hairpin cotter. Refer to

ﬁ gure 10 on page 7.

2. Refer to the vehicle owners manual for instructions on

safe operation on slopes.

3. Use the slope guide provided on page 9 of this manual

to determine whether slope angle is too steep for safe

operation.

4. Always test to make sure your tractor has adequate

towing and braking capabilities whenever hauling a

substantial amount of weight in your cart. Use extra

caution when operating on slopes.

CAUTION: VEHICLE BRAKING AND

STABILITY MAY BE AFFECTED WITH THE

ADDITION OF AN ACCESSORY OR AN

ATTACHMENT. BE AWARE OF CHANGING

CONDITIONS ON SLOPES.

5. For best handling and traction, distribute the weight of

the load evenly in the cart.

6. To dump material from the cart, remove the 1" long

clevis pin from the latch on the tongue and release the

latch. The cart bed will then tilt backwards to empty its

contents. After emptying, pull the front of the bed down

toward the cart tongue until the latch snaps into place.

Reinstall the clevis pin in the latch to prevent accidental

release of the latch.

7. The maximum towing speed for this cart is 10 m.p.h.

MAINTENANCE

1. At the beginning of each season, using a light machine

oil, lubricate the latch, the latch pivot bolt, and the area

of the axle where the draw bar tongue pivots .

2. Grease or oil the wheel bearings periodically. Use

automotive wheel bearing type grease or 20 weight

oil.

3. Check periodically for loose bolts.

4. Keep tires adequately ﬁ lled. Do not exceed the maximum

recommended pressure on tire.

ENGLISH

Do Not Exceed 500 Lb. Weight Capacity Of Cart

One cubic foot of dirt weighs approximately 80 lbs.

IMPORTANT!

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

Agri-fab 45-0345 User Manual Page 8

Comments to this Manuals

Related products and manuals for For the car Agri-fab 45-0345