8
FIGURE 14 (Left Hand Side View)
Assemble one 5/16 jam nut approximately 3/4" onto
threaded end of control cable. Assemble threaded cable
end through round hole in cable mount bracket and
secure with another 5/16 jam nut. Tighten. See figure
13.
NOTE: Some further adjustment may be required after
blade assembly is completed.
(Right Hand Side View)
FIGURE 15
NOTE: All hairpin cotters on this snow blade should be
pushed through to their loop end.
Place the end of the channel assembly up inside the
pivot support bracket. Align the hole second from the
end in the channel assembly with the front hole in the
pivot support bracket and secure through from the left
side with the channel pivot pin, the 1/2" washer and one
hairpin cotter. The hairpin cotter should be pushed all the
way through to the loop end. See figure 16.
Hook blade adjust spring over spring mount rod as
shown in figure 15. Remove plastic cap, and one 3/8"
hex nut from bolt assembled in spring. Adjust the re-
maining 3/8" hex nut down approximately 1" onto the bolt
threads. Assemble bolt up through the hole in top edge
of blade and hold in place with the 3/8" hex nut removed
earlier. Tighten 3/8" hex nut on top edge of blade down
against the bottom 3/8" hex nut. Replace plastic cap
over end of bolt threads. See figure 15.
NOTE: The other end of the control cable will be
attached in a later step.
Attach blade assembly to channel assembly by inserting
the blade pivot shaft from the left side (bend facing up)
through the notched holes in the blade and channel
assemblies. Secure with two 1/8" x 1-1/4" cotter pins
through two holes in pivot shaft. Spread ends of pins.
See figure 15.
Assemble ball end of control cable up through hole in
cable end fitting and pull till ball slips inside curled edge
of fitting. Note: If ball wont slip under edge of curl it will
need to be inserted through open end of curl. See figure
14
Assemble 1/4" x 1-1/4" hex bolt down through the cable
end fitting, the 5/8" long spacer and the left hand hole in
the channel assembly. Secure with a 1/4" hex lock nut.
See figure 14. Tighten.
FIGURE 13 (Left Hand Side View)
CHANNEL ASSEMBLY
5/16" JAM NUT
5/16" JAM NUT
CABLE MOUNT
BRACKET
1/4" x 1-1/4"
HEX BOLTCABLE END
FITTING
1/4" HEX LOCK NUT REAR
SPACER
(23658)
CHANNEL
ASSEMBLY
HOLE
(TOP)
3/8" HEX NUT
PLASTIC
CAP
3/8" HEX NUT
(BOTTOM)
BLADE
ASS’Y
1/8" x 1-1/4"
COTTER PIN
BLADE
PIVOT
SHAFT
SPRING
MOUNT ROD
CHANNEL
ASS’Y
BLADE
SHOE
BLADE ADJUST
SPRING
1/8" x 1-1/4"
COTTER PIN
(23 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals