Agri-fab 45-0320 User Manual download pdf (Page 13)

WHEEL GEAR AND PAWL SERVICE

IMPORTANT:

Do not

remove both wheels at the same

time to avoid mixing of parts. (The R.H. and L.H. ratchet

gears are not interchangeable.)

Make notes

on the position

of washers and snap rings during disassembly.

1. Remove

only one

wheel from the sweeper.

2. Remove the retaining rings and washers which hold the

ratchet gear onto the brush shaft.

(Figure 29)

Remove the gear by sliding it off the brush

(Figure 29) Remove the gear by sliding it off the brush (Figure 29)

shaft. (Look for the drive pin, which may fall out of the

brush shaft when the ratchet gear is removed.)

4. To reassemble, insert the drive pin through the hole

near the end of the brush shaft. Make sure the pin slides

back and forth easily in the shaft.

5. Lightly grease the shaft and ﬁ ll the ratchet gear with

grease. Assemble the ratchet gear back onto the

shaft.

6. Lightly grease the axle and the gear teeth on the wheel,

and then reassemble the wheel. The brushes should

rotate

only

during forward rotation of the wheel. If the

brushes are driven (rotated) by both forward and reverse

rotation of the wheel, the drive pin is jamming in the

ratchet gear. Disassemble to clean and lubricate the

drive pin and the ratchet gear.

7. Remove the second wheel and repeat the procedure.

BRUSH REPLACEMENT

NOTE:

Brush replacement should be done one brush at

a time.

1. Remove the hopper bag from the sweeper.

(Figure 28)

Loosen the hex bolts and lock nuts on two

(Figure 28) Loosen the hex bolts and lock nuts on two (Figure 28)

single brush retainers which clamp one brush to the

double brush retainers.

Do Not

loosen

or remove the

bolts which fasten the double brush retainers to the

brush shaft.

(Figure 28)

Slide the brush out of the retainers, noting

(Figure 28) Slide the brush out of the retainers, noting (Figure 28)

on which side of the brush the bristles overlap.

(Figure 28)

Install new brush, making sure the bristles

(Figure 28) Install new brush, making sure the bristles (Figure 28)

overlap on the same side of the brush as before.

1. Brushes set too low.

2. Brushes are jammed

3. Wheels are jammed.

Wheels skid when sweeping.

1. Adjust height till brushes are 1/2" down into grass.

2. Stop sweeper. Remove obstruction.

3. Remove one wheel at a time to check for obstruction or

damage. Refer to Service and Adjustments section.

SERVICE AND ADJUSTMENTS

TROUBLESHOOTING

ENGLISH

BRUSH ROTATION

OVERLAP

BRISTLES

OVERLAP

BRISTLES

SINGLE

BRUSH

RETAINERS

DOUBLE BRUSH RETAINER

BRUSH

SHAFT

RATCHET

GEAR

DRIVE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments

Agri-fab 45-0320 User Manual Page 13

Comments to this Manuals

Related products and manuals for Gardening equipment Agri-fab 45-0320