Agri-fab 45-0320 User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
5
TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16" Open End or Box End Wrenches
(2) 1/2" Open End or Box End Wrenches
ASSEMBLY
All loose parts are shown on page 2. Fasteners in the parts
bag are shown full size on page 3.
Remove the hardware pack and all loose parts from the
carton and verify that all the parts and fasteners shown on
pages 2 and 3 are included.
ASSEMBLY OF SWEEPER
Note:
Right hand (R.H.) and left hand (L.H.) are determined
from the operator's position while seated on the tractor.
1.
(Figure 1)
Place the sheet of cardboard from inside the
(Figure 1) Place the sheet of cardboard from inside the (Figure 1)
carton onto your work surface to prevent scratching the
sweeper. Turn the sweeper housing upside down on the
cardboard, facing the direction shown.
2.
(Figure 1)
Assemble the rear support brace to the holes
(Figure 1) Assemble the rear support brace to the holes (Figure 1)
indicated in the sweeper housing. Use two 1/4" x 1/2"
hex bolts (H) and 1/4" nylock nuts (I).
ENGLISH
1/4" x 1/2"
HEX BOLT (H)
1/4" NYLOCK NUT (I)
USE THIS HOLE
1
3.
(Figure 2)
Each brush assembly has one brush retainer
(Figure 2) Each brush assembly has one brush retainer (Figure 2)
marked with either red or black ink. Lay out the brush
assemblies as shown so that the brush retainers marked
with ink are in the middle with the red one on the right
and the black one on the left.
OVERLAP BRISTLES
BRUSH RETAINER
MARKED BLACK
BRUSH RETAINER
MARKED RED
2
IMPORTANT:
The overlap bristles at the bottom of each brush
help support the back side of the brush for better sweeper
performance. Be sure the sweeper is turned as shown in
gures 2 and 3 to correctly assemble the brushes.
4.
(Figure 3)
Attach the brush assembly with the red
(Figure 3) Attach the brush assembly with the red (Figure 3)
brush retainer to the right end of the brush shaft using
two 1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The
brush retainer marked with red ink must be placed to
the
middle
of the sweeper.
BRUSH RETAINER
MARKED RED
OVERLAP
BRISTLES
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
BRUSH RETAINER
MARKED RED
3
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments