Agri-Fab 45-0418 Owner's Manual download pdf (Page 13)

KNOWYOURSNOWTHROWER

Read this owner's manual and safety rules before operating your snow thrower.

Compare the illustration below with your snow thrower to familiarize yourself with the various controls and their locations.

UPPER CHUTE

LOWER CHUT_'_

CHUTE TiLT

HANDLE

ON/OFF

SWITCH

LEVER

CRANK

ROD

_ HANDLE BAR

SWITCH

SPIRAL AUGERS

R.H. & L.H.

SKiD SHOE

TETHERED SAFETY

SWITCH

SCRAPER PLATE

CHUTE TiLT HANDLE -- Pivots the Upper Chute up or

down to control the angle and distance of discharge.

CRANK ROD -- Rotates the Lower and Upper Chutes to

control the direction of discharge.

UPPER AND LOWER DISCHARGE CHUTE -- Controls

direction and height of snow discharge.

SCRAPER PLATE -- Replaceable plate that absorbs

wear and impact from contact with ground.

SKiD SHOE -- Controls amount of clearance between the

scraper plate and the ground.

SPIRAL AUGER, R.H. & L.H. -- Feeds snow to the

impeller fan at the center of the housing.

ON/OFF SWITCH -- Allows snow thrower engine to be

turned off when sitting on ATV.

HANDLE BAR SWITCH -- Raises and lowers the snow

thrower.

TETHERED SAFETY SWITCH -- Turns snow thrower off

when pulled out.

CLUTCH LEVER -- Engages and disengages the spiral

augers.

HOWTO USEYOUR SNOWTHROWER

CAUTION: Never direct discharge

towards bystanders or windows. Do not

allow anyone in front of unit.

BEFORE STARTING

• Use the end of assembly checklist to verify that all

instructions have been properly completed.

Make sure the skid shoes are adjusted to maintain

adequate ground clearance between the snow thrower

and the type of surface to be cleared. (Refer to the

Service and Adjustments section.)

Make sure the ATV engine has the correct oil for winter

operation. Refer to ATV owner's manual.

HOW TO START YOUR SNOW THROWER

Set clutch lever to "DISENGAGED"

= Attach the pull out plug to the tethered safety switch. The

snow thrower will not run if the plug is not attached.

= Set on/off switch on control mount to "ON"

• Follow instructions in your Engine Operator's Manual

to start the snow thrower engine, then continue below.

= Board your ATV and move clutch lever on control

mount to "ENGAGED" position

HOW TO STOP YOUR SNOW THROWER

Set clutch lever on control mount to "DISENGAGED"

Set on/off switch on control mount to "OFF"

Follow instructions in your Engine Operator's Manual

to finish Stop Engine procedures.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Comments to this Manuals

No comments

Agri-Fab 45-0418 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Snow throwers Agri-Fab 45-0418