Agri-Fab 45-0418 Owner's Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 23
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
SNOW THROWER ASSEMBLY
.
Remove any CV boot guard or stick guard from the
front lower A arms of the ATV. Select the correct strut
mount assembly shown in figure 6 for your ATV. If your
ATV is not listed in figure 6, start with the 5-1/2" strut
mount assembly. If you use the 4", 5-1/2" or 6-5/8" strut
mount assemblies, attach with the strut mount on the
bottom of the A arm and the bolts on the outside of the
A arm. Do not tighten bolts at this time.
__A 4" Strut Mount
_3/8" x2"
6-5/8" Strut
Strut \ Mount
Mount 3/8" × 2"
' -1/2"--4
6-5/8" Strut _I Bombardier
Mount \ Out(ander Strut
3/8" × 2" Mount
\
3/8" × 2"
FIGURE 6
3. Slide a collar over the end of the outer mount strut.
4. Slide the outer mount strut through the brackets
assembled in step 2.
5. Slide a second collar over the end of the outer mount
strut.
6. Apply a light coat of grease to the inner mount strut
and then insert it into the outer mount strut.
7. Tighten the bolts assembled in step 2.
OUNT STRUT
COLLAR
INNER
MOUNT
STRUT
/
COLLAR
FIGURE 8
8. Fasten the ends of the inner and outer mount struts
to the strut mount assemblies that you attached to the
ATV's A-arms. Use two (2) 1/2" x 3" clevis pins and two
(2) hairpin cotters.
9. Tighten the bolts and nuts assembled in step 1 that
fasten the strut mount assemblies to the A-arms.
10. Center the stabilizer brackets under the ATV. Slide the
collars up against the stabilizer brackets and tighten
the set screws in the collars. The stabilizer brackets
must rotate freely after the collars are tightened.
NOTE: The ATV is not shown below for clarity.
.
Assemble the stabilizer brackets together using (2)
1/2" x 4-1/2" hex bolts, (2) 3" long spacers and 1/2"
nylock nuts as shown in figure 7. Do not tighten yet.
/ 112"x 4-112"
HEX BOLT
J
3" LONG
SPACER
STABILIZER
BRACKET
I_"NYLOCK NUT
HAIRPIN
COTTER
"------ 112" x 3-112"
CLEVIS PIN
1/2" x 3"
CLEVIS PIN
HAIRPIN COTTER _
FIGURE 9
FIGURE 7
7
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Comments to this Manuals

No comments