Agri-Fab 45-0491 Operations Instructions download pdf (Page 11)

STEP15: (SEEFIGURE13)

* Find the cable clip that is attached to the left side

of the tractor frame underneath the footrest. Open

the clip and remove the mower clutch cable. Do not

remove the clip from the tractor frame. The cable

reattaches to the clip when using the mower deck.

* Move the attachment clutch lever on the dash panel to

the disengaged position.

* Place the clutch/idler assembly on the floor on the left

side of the tractor.

* Attach the tractor's mower clutch cable to the cable

bracket on the clutch/idler assembly. Secure the cable

housing guide (groove down) to the cable bracket

using the original collar and retainer spring.

* Place a 1/4" spacer on the welded pin on the idler

arm. Hook the end of the clutch cable spring over the

pin and secure it with a 1/4" washer and a 5/64" hair

cotter pin.

* Align cable bracket with welded pin and tighten the

nut assembled in step 11.

PIVOTLOCK PiN 1/8" HAiRPiN NYLONTiE

(use this hole) COTTER

L.H. HANGER SHOULDER

BOLT

FIGURE 14 VIEWED FROM LEFT SiDE

1/4" SPACER

TRACTOR'S

CLUTCH CABLE

CABLE

BRACKET

FIGURE 13

ATTACH CLUTCH iDLER ASSEMBLY TO TRACTOR

STEP 16: (SEE FIGURE 14)

* Attach the clutch/idler assembly to the tractor frame.

Hook the notched rear pulley frame brackets onto the

two shoulder bolts assembled to the outside of the

tractor frame. Lift the front of the assembly and attach

it to the R.H. and L.H. hanger brackets using two pivot

lock pins and 1/8" hairpin cotters.

* Loosely attach the mower clutch cable to the left side

of the tractor frame with a nylon tie. Do not pull the

nylon tie completely tight. The cable may need to be

removed from the nylon tie when using the mower

deck.

STEP 17: (SEE FIGURE 15)

* Assemble the drive belt onto the engine pulley, routing

it through the engine pulley belt keepers.

HINT: You may need to remove the belt from the large

pulley on the clutch/idler assembly in order to assemble

it onto the engine pulley. When re-assembling the belt

onto the large pulley, be sure the belt is between the large

pulley and the hex bolt next to it.

* Go to step 24 on page 14.

HEX BOLT • ......

LEFT SiDE

OF TRACTOR

4;;'

_ sS; ¸¸

ENGINE FLAT IDLER

E_GINE PULLEY PULLEY

PULLEY BELT KEEPERS

FIGURE 15 VIEWED FROM UNDERNEATH

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Agri-Fab 45-0491 Operations Instructions Page 11

Comments to this Manuals

Related products and manuals for Snow throwers Agri-Fab 45-0491