Agri-Fab 45-0491 Operations Instructions download pdf (Page 16)

STEP30: (SEEFIGURE28)

• Placetheendofthewinchcableontotheliftlink.

Placea 1/2"washerontothelinkandinstalla5/64"

hairpincotter.

HINT:Pushontheliftstopplateto rotatetheliftlinkinto

betterpositionto installthewinchcable.

_WINCH CABLE

LIFT STOP

PLATE

5/64" HAIRPIN

COTTER

It111J

LIFT LINK

IIIIII

1/2" WASHER

PUSH HERE

iNSTALLiNG THE AUGER BELT

STEP 32: (SEE FIGURE 30)

Start with the snow thrower lowered to the ground.

Swing the idler arm over to the L.H. side of the tractor.

Place the auger belt around the rear V-pulley and

between the two idler arm pulleys. The "V" side of the

belt must be seated in the grooves of the V-pulleys.

HINT: If the belt is too tight to assemble, try temporarily

releasing the spring tension on the upper drive belt and

then turning the rear pulley while rolling the auger belt

onto it. If the belt is still too tight to assemble, try raising

the snow thrower to see if the belt is looser in that position.

LEFT SiDE

OF TRACTOR

FIGURE 28 VIEWED FROM UNDERNEATH

STEP 31: (SEE FIGURE 29)

Check to make sure the auger belt is still properly

seated around the snow thrower's auger pulley and

idler pulleys.

TWIST

1/4 TURN

iDLER

PULLEY

AUGER PULLEY

TWIST

1/4 TURN

iDLER

PULLEY

FIGURE 29

FIGURE 30

REAR

PULLEY

IDLER ARM

FLAT PULLEY

iDLER ARM V=PULLEY

AUGER

BELT

VIEWED FROM UNDERNEATH

BELT ROUTING DIAGRAM

ENGINE PULLEY

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

Agri-Fab 45-0491 Operations Instructions Page 16

Comments to this Manuals

Related products and manuals for Snow throwers Agri-Fab 45-0491