Agri-Fab 45-0491 Operations Instructions Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
15
FIGURE 25 RIGHT SIDE VIEW
CHUTE KEEPER
ANTI-ROTATION
BRACKET
1/4" FLANGED
LOCK NUT
1/4" FLAT
WASHER
1/4" x 1"
HEX BOLT
PLASTIC CAP
GREASED
SURFACE
FLANGE
STEP 27: (SEE FIGURE 25)
• Coatthetopoftheringaroundthedischargeopening
with general purpose grease.
• Placethedischargechute(facingforward)ontothe
ring.Placetheanti-rotationbracketontopofthechute
ange,aligningitwiththeholesontherighthandside
oftheange.Attachthethreechutekeepers(right
sideupasshown)tothebottomoftheangeusing
six1/4"x1"hexbolts,1/4"atwashersand1/4"
angedlocknuts.Tighten carefully so that the nuts
aresnugbutdonotdigintotheplasticchutekeepers.
• Placetheplasticcapontotheshortendoftheanti-
rotationbracket.
• Positionthecrankrodspiral(seegure24onpage
14)sothatitdoesnotrubagainstthebottomsofthe
notchesinthechuteange.Tighten the nuts.
• Checkifthecrankrodrotatesthechutefreely.Ifnot,
loosenby1/4turneachofthesixhexboltsholding
thechutekeeperstothechuteange.
• Securethecontrolcablestothecrankrodsupport
tubeusingtwonylonties.
ATTACHING SNOW THROWER TO TRACTOR
FIGURE 26 RIGHT SIDE VIEW
STEP 28: (SEE FIGURE 26)
• Placethesnowthroweronaat,levelsurface.
• Extendtheaugerbeltoutbehindthesnowthrower,
leavingthebeltassembledtothesnowthrowerpulleys.
• Rollthetractorupbehindthesnowthrower,centering
itbetweenthesnowthrower'smountingplates.
• Liftuponthecrankrodsupporttubetoraisethe
rear of the snow thrower and align the notches in the
mountingplatesalignwiththeshoulderboltsinthe
tractor'ssideplates.Rollthetractorforward,guiding
theshoulderboltsintothenotches.
• Installthetwo1/2"x7/8"clevispinsand1/8"hairpin
cotters to secure the snow thrower to the tractor.
1/8" HAIRPIN
COTTER
1/2" x 7/8"
CLEVIS PIN
TERMINALS
FIGURE 27 RIGHT SIDE VIEW
STEP 29: (SEE FIGURE 27)
• Connecttheterminalsofthewireharnessattachedto
thetractorwiththewireterminalsofthelimitswitches
on the snow thrower.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments